piolt pioneer窗口参数含义及中英文对照.doc

Piolt Pioneer窗口参数含义及中英文对照 1、TD Radio窗口参数名称参数描述PCCPCH RSCP(dBm)主公共控制物理信道的平均接收信号码功率（Primary Common Control Physical Channel Received Signal Code Power. from -115 to -25）DPCH RSCP(dBm)专用物理信道的平均接收信号码功率(Dedicated Physical Channel Received Signal Code Power. The value range is from -120 to -57)Path Loss(dB)主公共导频信道的路径损耗 (The path loss of Primary Common Pilot Channel)UTRA Carrier RSSI(dBm)载波（RSSI-接收信号强度）(The UTRA Carrier RSSI which the value range is from -94dBm to -32dBm)Time Advance(Chip/8)时间提前量 (Timing Advance used to compute the distance between NodeB and MS)UpPCH TxPower(dBm)UE在一个载波上上行导频信道的平均发射功率(Uplink Pilot Channel Transmit Power)BLER (%)传输信道的块错误率—误块率(Block Error Ratio)UE_TxPower(dBm)UE在一个载波一个时隙上的平均发射功率(User Equipment Transmit Power)PCCPCH SIR(dB)主公共导频信道的SIR(The SIR of Primary Common Control Physical Channel)C/I(dB)载干比(Carrier-to-interference ratio)UARFCN主服务小区的主频点(UTRA Absolute Radio Frequency Channel Number)TrCH CountDRX循环长度系数，用于计算指定UE的寻呼次数(The total counts of Transmit Channel)CS Service传输信道的总个数(The coding ratio of Circuit Switch Service. The unit is kbps)PS Service电路交换业务的编码速率(The transmit ratio of Packet Service. The unit is kbps)DRX Coefficient分组交换的传输速率(Discontinuous Reception Coefficient used to compute the paging numbers of UE)SS帧同步偏移(Synchronization Shift)2、TD Serving/Neighbor窗口参数名称参数描述UARFCN主服务小区的主频点CPI小区识别符(Cell Parameter Identifier)RSCP(dBm)接收到的信号功率强度(Received Signal Code Power)Carrier RSSI(dBm)载波RSSI(The UTRA Carrier RSSI which the value range is from -94dBm to -32dB)Path Loss(dB)路径损耗Rs/Rn小区重选判决准则参数(The standard parameters to judge cell reselction)Cell Name小区名称Distance(m)UE与服务小区的距离(The distance between UE and serving cell)3、TD System Parameters窗口参数名称参数描述MCC国家识别码(Mobile Country Code (0---999))MNC网络识别码(Mobile Network Code (0---99))LAC位置区域码(Location Area Code)RAC路由区域码(Routing Area Code)Cell ID小区ID(Cell Identifier)PCCPCH TxPower(dBm)PCCPCH信道的发射功率(The TxPower of Primary Common Control Physical Channel)QRxLevelMin(dBm)要求的最小接收信号电平(The required minimum received signal Rx level)UAR ID List小区列表(The Cell Identifier list)SintraSearch(dB)小区内重选启动门限电平(Intracells Reselection Threshold)SinterSearch(dB)小区间重选启动门限电平(Intercells Reselection Threshold)TreSelection(ms)小区重选计时器值(The value in timer for cell reselection)Cell Barred小区扇区(The cell barred symbol)Maximum Allowed UL TxPower(dBm)UE的最大允许发射功率(The maximum allowed UE TxPower)Qhysts小区重选时接收信号质量的滞后量()ATT Allowed附着允许标识(The attached allowed symbol)NMO网络工作模式，用于指示位置更新和路由更新的方式(Network working mode of operation used to show the way of location update and routing area update)T3212周期性位置更新定时器(The timer for periodical location update)4、Time Slot窗口参数名称参数描述Time Slot时隙序号(The Time Slot order)ISCP(dBm)每个时隙每个载波上的干扰信号码功率(Interference Signal Code Power)DPCH TSDPCH是否占用该时隙的标志(The symbol whether Dedicated Physical Channel occupies the Time Slot.)DPCH RSCP(dBm)每个时隙每个载波上的DPCH信道的RSCP(Dedicated Physical Channel RSCP)5、Physical Channel窗口参数名称参数描述Repeat Period and Length重复周期优先级和重复长度(The repetition period and repetition length)MidambleAllocation中导码分配情况指示(The allocation of Midamble)MidambleConfiguration配置的中导码序号(The configuration of Midamble)6、Transport Channel窗口参数名称参数描述TrCH ID传输信道编号(Transport Channel Identifier)Type传输信道当前占用类型(The type of occupied Transport Channel)BLER (%)传输信道的块错误率(The Block Error rate of Transport Channel)7、TD State窗口参数名称参数描述Main Current State之前RRC连接的状态(The main current state of RRC connection)Main Later State当前RRC连接的状态(The main later state of RRC connection)Connected Current State当前RRC连接的子状态(The connected current state of RRC connection)Connected Later State当前RRC连接的子状态(The connected later state of RRC connection)Service Level小区的服务状态(The service state of cells)8、Power Control窗口参数名称参数描述Target DCH SIR目标专用信道信干比(Target DCH Signal-to-Interference Ratio)DCH SIR专用信道信干比的测量值(Dedicated Channel Signal-to-Interference Ratio)TPC指示闭环功率控制的方向，功率调整的动态范围为80dB(Transmit Power Control)TPC Step功率控制步长(Transmit Power Control Step)9、Throughput窗口参数名称参数描述UL RLC Throughput（bps）上行RLC层流量(The throughput of uplink RLC, the value being from 0 to 64000 bps)DL RLC Throughput（bps）下行RLC层流量(The throughput of downlink RLC, the value being from 0 to 384000bps)UL PDCP Throughput（bps）上行PDCP层流量(The throughput of uplink PDCP, and the value ranges from 0 to 64000 bps)DL PDCP Throughput（bps）下行PDCP层流量(The throughput of downlink PDCP, and the value ranges from 0 to 384000 bps)UL RLC Retransmit Rate（%）上行RLC层重传率(The transmit rate of uplink RLC)DL RLC Error Rate（%）下行RLC层错误比率(The error rate of downlink RLC)10、UE Information窗口参数名称参数描述TMSI临时身份识别号(Temporary Mobile Subscriber Identity)PTMSI临时身份识别信息包(Packet Temporary Mobile Subscriber Identity)IMSI国际移动用户标识(International Mobile Subscriber Identity)　。