机械专业外文文献翻译-外文翻译---负载运行的变压器及直流电机导论负载运行的变压器

1、The Transformer on loadIntroduction to DC MachinesThe Transformer on loadIt has been shown that a primary input voltage can be transformed to any desired open-circuit secondary voltage by a suitable choice of turns ratio. is available for circulating a load current impedance. For the moment, a lagging power factor will be considered. The secondary current and the resulting ampere-turns will change the flux, tending to demagnetize the core, reduce and with it . Because the primary leakage impedan

2、ce drop is so low, a small alteration to will cause an appreciable increase of primary current from to a new value of equal to . The extra primary current and ampere-turns nearly cancel the whole of the secondary ampere-turns. This being so , the mutual flux suffers only a slight modification and requires practically the same net ampere-turns as on no load. The total primary ampere-turns are increased by an amount necessary to neutralize the same amount of secondary ampere-turns. In the vector e

3、quation , ; alternatively, . At full load, the current is only about 5% of the full-load current and so is nearly equal to. Because in mind that , the input kVA which is approximately is also approximately equal to the output kVA, .The physical current has increased, and with in the primary leakage flux to which it is proportional. The total flux linking the primary , is shown unchanged because the total back e.m.f.,（）is still equal and opposite to . However, there has been a redistribution of f

4、lux and the mutual component has fallen due to the increase of with . Although the change is small, the secondary demand could not be met without a mutual flux and e.m.f. alteration to permit primary current to change. The net flux linking the secondary winding has been further reduced by the establishment of secondary leakage flux due to , and this opposes . Although and are indicated separately , they combine to one resultant in the core which will be downwards at the instant shown. Thus the s

5、econdary terminal voltage is reduced to which can be considered in two components, i.e. or vectorially . As for the primary, is responsible for a substantially constant secondary leakage inductance . It will be noticed that the primary leakage flux is responsible for part of the change in the secondary terminal voltage due to its effects on the mutual flux. The two leakage fluxes are closely related; , for example, by its demagnetizing action on has caused the changes on the primary side which l

6、ed to the establishment of primary leakage flux.If a low enough leading power factor is considered, the total secondary flux and the mutual flux are increased causing the secondary terminal voltage to rise with load. is unchanged in magnitude from the no load condition since, neglecting resistance, it still has to provide a total back e.m.f. equal to . It is virtually the same as , though now produced by the combined effect of primary and secondary ampere-turns. The mutual flux must still change

7、 with load to give a change of and permit more primary current to flow. has increased this time but due to the vector combination with there is still an increase of primary current.Two more points should be made about the figures. Firstly, a unity turns ratio has been assumed for convenience so that . Secondly, the physical picture is drawn for a different instant of time from the vector diagrams which show , if the horizontal axis is taken as usual, to be the zero time reference. There are inst

8、ants in the cycle when primary leakage flux is zero, when the secondary leakage flux is zero, and when primary and secondary leakage flux is zero, and when primary and secondary leakage fluxes are in the same sense.The equivalent circuit already derived for the transformer with the secondary terminals open, can easily be extended to cover the loaded secondary by the addition of the secondary resistance and leakage reactance.Practically all transformers have a turns ratio different from unity alt

9、hough such an arrangement is sometimes employed for the purposes of electrically isolating one circuit from another operating at the same voltage. To explain the case where the reaction of the secondary will be viewed from the primary winding. The reaction is experienced only in terms of the magnetizing force due to the secondary ampere-turns. There is no way of detecting from the primary side whether is large and small or vice versa, it is the product of current and turns which causes the reaction. Consequently, a secondary winding can be replaced by any number of different equivalent windings and load circuits which will give rise to an identical reaction on the primary .It is clearly convenient to change the secondary winding to an equivalent winding having the same number of turns as the primary. With changes to , since the e.m.f.s are proportional to turns, which is the same as .For current, since the reaction ampere turns must be un

《机械专业外文文献翻译-外文翻译---负载运行的变压器及直流电机导论负载运行的变压器》由会员cn****1分享，可在线阅读，更多相关《机械专业外文文献翻译-外文翻译---负载运行的变压器及直流电机导论负载运行的变压器》请在金锄头文库上搜索。