环氧酚醛油罐涂料导静电涂料.doc

Intended Uses用途薄膜油罐涂料用于储存范围广泛的物质包括含混合酒精的汽油和能引起火灾的易燃液体的油罐和容器内壁等As tank coating with thin film, suitable for interior of tank and container which can store substances of wide range covering gasoline containg mixied alcohol and flammable liquid easy to give rise to fire.ProductInformation产品简介HYGT394-1：黑色，采用碳系导电介质HYGT394-2浅灰色，采用金属氧化物复合导电介质HYGT394-1：Black Using conductive carbon black or grapgite powder as conductive madiumHYGT394-2: Light grey, Using metalic oxide modified micapowder as conductive mediumApplication details产品数据Volume Solids 固体份≥50%ccording 50%Dry Flm Thickness干膜厚度125 microns 125微米Theoretical Coverage 理论涂布率2.68 m2 /Kg 2.68平方米/公斤Practical Coverage 实际涂布率Allow appropriate loss 允许适量损耗Storage and Handling施工详述Mix Radio 混合比A:B=4:1(by weight ) 甲:乙=4:1(重量比)Method of Application 施工方法 Airless Spray 无空气喷涂 Recommended 推荐采用 Brush or Roller 涂刷或辊涂 Recommended 推荐采用 Conwentional Spray 传统喷涂 Not Recommended 不推荐采用 Thinner 稀释剂 Not necessary in normal, with the exception of using temporary primer, if needed, use C003 除适用临时性底漆外，如需要使用C003（最多稀释5%）Cleaner 油漆设备清洗剂 C003Pot Life 使用期 15min under the conditions of 10-35℃ 15分钟，在10-35℃条件下Storage 贮存期 One year 一年Drying time 干燥时间SubstrateTemperature底材温度Touch Dry表干（h）Hard Dry硬干(h）Over coating Interval覆涂间隔Mix最短Max最长25℃23℃35℃63124161224hours 小时 24hours 小时24hours 小时14days7days3days 环氧酚醛油罐涂料（导静电涂料）StorageandHandling贮存与管理Storage 贮存 Store under dry, cool conditions and less than 35 ℃ 贮存于干凉条件下，不高于35℃Pack size 包装规格 A;16Kg in 20 liter container 甲:16公斤装于20公升容器中 B:4Kg in 4 liter container 乙:4公斤装于4公升容器中Flash Point 闪点 Above 20℃(components or their mixture) 高于20 ℃（组成物或其混合物）Specific Gravity 比重 1.49Kg/L 1.49公斤/公升Specification and Surface preparation技术要求及表面处理Consult over company about the minute information of interior painting.The surface to be coated must be clean, dry and free from dirt, Remove grease from surface according to SSPC-SP1 by solvent cleaning, If necessary, remove weld slag, smooth weld seams and sharp edges.Blast clean to Sa2.5(Swedish Standard SIS055900). The steel must be coated with the electric conductive coating prior to steel oxidation, If oxidation hanve happened, completely oxidized parts should be blasted again to the stipulated standard咨询本公司有关内壁涂装的详细资料。

覆涂的表面必须清洁干净，干燥无污物，根据 SSPC-SP1用溶剂清洗，去除表面油脂，在需要之处，去除焊渣，磨平焊道和尖锐边缘，喷砂处理至 Sa2.5（瑞典标准 SIS055900）该道静电漆必须在钢材氧化发生前涂装，如氧化已发生，完全氧化的部分应重新喷砂至上述规定标准 Limitations 限制 Whether this product is suitable for goods to be stored shall be approved in advance by the company.This productcan not fully cure at low temperature. The steel temperature should be above 10℃ and at least 3 ℃above the dew point, and relative humidity is more than 80%, so as to obtain the optimum curing effect.咨询本公司以确认本产品是否适用于储存该物品本产品在低温条件下，无法充分固化，为求最佳固化效果，钢板温度应高于10℃，且至少高于露点3℃，大气相对湿度最大应为80% Safety Precautions 安全措施This product should be used in painting area by perfessional operators. When painting , please refer to Product Data Sheet and MSDS. Consult our company if consumers could not completely understand the precautions for safety and health when applying this product.This product is a kind of solvent-based paint .Inorder to avoid danger or accident, minimal safety precautions,as follow , should be down .The paint contains volatile solvent and is flammable . So must keep away from sparks and open flames.No smoking at applacation site ,Effective precautions (such as using explosion-proof electrical equipments. No static electricity accumulation or metal collision etc) also should be done so as to avoid producting sparks .Flash point of paint , mentioned above on product Data sheet, is the lowest temperature at which mixture of the volatile materails of paint can ignite or explode with air. Enough ventilation is necessary at application site. In order to remove any danger of explosion, must keep the ratio of gas to air is less than 10%, the minimum explosive limit in general, Therefore, 200m3 of ventilation quantuty per 1Kg solvent (according to the solvent ) is necessary.Product skin and eyes, and avoid touching with paints (Recommend to wear working clothes, gloves,eye protection, face masks barrier cream and so on ). Kif paint gets in touch with skin , wass fully with large amount of fresh water and soap or appropriate commercial cleaner. In case of eyes bei。