1、本科毕业论文（设计）相关中英文翻译资料资料题目：频谱分析在转子动平衡中的应用学生姓名： 所在院系：机电学院所学专业：机电技术教育指导老师：APPLICATION OF FREQUENCY SPECTRUM ANALYSIS IN THE ROTATOR MOVING EQUILIBRIUMABSTRACTThe experimental equipment is developed to simulate the rotator vibration. The running state of machine is simulated by using different running conditions. The vibration caused by non-equilibrium mass is analyzed and discussed for first order with focus load. The effective method is found out by using frequency spectrum analysis. INTRODUCTION In
2、 the conventional island of nuclear power plant, turbine generator set is a very important equipment in which the core thermal energy is transferred into electric energy. When the turbine generator set has run for long time, the original equilibrium of system would be upset because of the remnant deformed of the metal, abrasion or damaging of the components etc. As a result, the vibration will be increased. So it is necessary to adjust the equilibrium at spot. On the other hand, a large turbine
3、generator set also needs the work for adjusting the equilibrium in the process of manufacture, debugging, installation and operation. The moving equilibrium technique at spot is an important means to eliminate the violent vibration of the turbine generator set. We could have a definitely view for the vibration type, vibration power source and vibration property by analyzing the vibration of the turbine generator set or doing some special experiment. When the vibration signal is obtained, the fre
4、quency spectrum could be used to analysis the vibration signal in order to diagnose quickly. Using frequency spectrum analysis, the electrical signal of vibration that is obtained by the vibration sensor and has a wide frequency range will be decomposed into several main frequency compositions. Different frequency compositions have different influence on the turbine generator set. The frequency spectrum analysis is a very useful method to study the vibration of turbine generator set. The vibrati
5、on caused by rotator mass non-equilibrium with concentrated load is discussed and analyzed in this paper. And an effective method to prevent the vibration is presented by using frequency spectrum analysis. 1 EXPERIMENTAL EQUIPMENT The experimental system consists of the motor, shaft coupling and rotor etc. Its structure is very simple. The rotor is driven by the motor directly. Its rotating speed could be adjusted in a wide range. The system could be operated smoothly and reliably. The rated cur
6、rent of the motor is 2.5 A, the output power is 250 W. The field excitation of the motor is provided by the 220 V AC power source which is commutated by the speed regulator, the armature current of the motor is also provided by the same power source. It is adjusted by the compressor governor. Through adjusting the output voltage of compressor governor, the motor could be of step-less speed regulated at the range 010000 r/min, the rate of velocity increasing could be 800 r/min. The length of the
7、experimental equipment is 1200 mm, the width is 108 mm, the mass is about 45 kg, the diameter of the shaft is 9.5 mm, the length of the shaft is 500 mm and the maximum deflection is less than 0.0050.015 mm. Any position along the axial direction could be selected as experimental abutment point. The diameter and mass of the experimental rotating table is 7619 mm and 600 g, respectively. The arrangement of experimental equipment is shown in Fig.1.Fig. 1 The arrangement of experimental equipmentThe
8、 electrical vortex sensors are used to measure the relatively displacement or vibration for axis to bearing pedestal. They are installed in the x and y directions at the sensor support, respectively. They do not touch the shaft, and could be used to directly measure the vibration signal of the rotation shaft. The flashing phase-measurer is used to measure the rotator speed and the phase of the shaft. 2 THE FREQUENCY SPECTRUM ANALYSIS OF VIBRATION SIGNAL The real vibration of turbine generator se
9、t is the most of simple harmonic periodic motion. Its wave type is also made of many simple harmonic motion. In order to analysis the vibration, we should study the wave type, the frequency composition of the vibration, and the amplitudes. Frequency can be used as x-axis to describe the vibration in the frequency-domain. The method decomposing the vibration into its various frequency components in frequency components in the frequency domain is called frequency spectrum analysis. The purpose of frequency spectrum analysis is to decompose the signals into different compositions. So the vibration becomes the simple harmonic motion including different amplitudes, frequencies and phases. In the frequency spectrum of rotator vibration, the different frequency is often corresponding to the different reason. If we can find the frequency composition of the vibration signal, the reason
《中英文翻译--频谱分析在转子动平衡中的应用.doc》由会员博****1分享，可在线阅读，更多相关《中英文翻译--频谱分析在转子动平衡中的应用.doc》请在金锄头文库上搜索。
