磁带备份hpux.doc

用 make_recovery 磁带恢复操作系统1. Power up the server 3. Upon seeing the following prompt in the console screen, press any key on the keyboard to interrupt the auto-boot process …. To discontinue, press any key within 10 seconds. …. 4. You should see the following prompt when the auto-boot process is interrupted Main Menu: Enter command >; 5. Insert the latest system backup tape. 6. You can use command sea to search to bootable media. Note the device type “Sequential access media”, which indicates it is the bootable tape. Then boot from it. Main Menu: Enter command >; sea Searching for potential boot device(s) This may take several minutes. To discontinue search, press any key (termination may not be immediate) Path# Device Path (dec) Device Path (mnem) Device Type ------------------------------------------------------------------- P0 0/0/1/0.3 extscsi.3 Sequential access media P1 x/x/x/x.x extscsi.2 Random access media P2 x/x/x/x.x intscsia.6 Random access media …… 9. Type in the boot command: Main Menu: Enter command >; boot p0 10. The bootstrap of the tape will be loaded into memory until you see the following question Interact with IPL (Y, N, or Cancel)? >; 11. Answer “N“ to follow the automatic recovery of the Production Server 12. The following message will then be display. Press ; key to acknowledge the message and continue the recovery process. Press Return to continue: 13. The following message will then be display. Press ; key to acknowledge the message and continue the recovery process. …. [ Install HP-UX ] [ Run a Recovery Shell ] [ Advanced Options ] …. 14. Use the ;, ;, or ; keys to navigate and highlight the “Install HP-UX“ option, and press ; key to select the option. The system will then display the next screen. Use the ; key to navigate and ; key to select the following options. Once the options are selected, use ; key to navigate to [OK] and press ; to acknowledge ok to proceed. …. Source Location Options: ….  Media only installation …. User Interface Options: ….  Advanced Installation (recommended for disk and file system management) …. 15. The system will then start loading the user configuration interface program. The “/opt/ignite/bin/tool“ menu is displayed. Under the “Basic“ tab, Make sure the configuration entries of “[Root Disk …]“ display the following: Configurations: [HP-UX System Recovery ->;] [Description …] Environments: [Recovery Archive ->;] (HP-UX B.11.00) [Root Disk …] SEAGATE_ST34573N File System: [HP-UX save_config layout ->;] [Root Swap (MB) …] 512 Physical Memory (RAM) = 256MB [Languages …] English [Keyboards …] [Additional …] …… [hostname…] [IP Address …] Subnet Mask: . [Set Time Zone …] [Network Services…] [Set Root Password …] [Additional Interfaces…] …… 16. Use ; key to navigate to “[Go !]“, and press ; key to proceed. Message prompt that disks and (or and) will be used as root disk. Warning also prompt that the 2 disks seem to have data on it. 17. Use ; key again to navigate to “[Go !]“ and press ; key again to confirm the restoration process. 18. The server will continue the recover process and will be rebooted after successfully completed the restore.。