KT板航模遥控飞机F16制作图纸.doc

INCH10234Sides (Make 2)Doublers\Right AileronRight Elev onControl pointMax prop size 6"Cut here for rudder (Optional)Left ElevonLeft AileronRudder (Optional)Lower Front FuseControl pointLower Rear FuseDepron = 6mmWing span = 71cm (28")Length = 104cm (41 〃)‘Cut here for rudder (Optional)CMoF-16C FALCON - EASYBUILD - V1.02Designed by Nick CaraSETUPWeight (painted) = 356gWeight (painted and with battery) = 486gStatic thrust = 650gProp = 6x4Motor = 2000kvESC = 25A minimumBattery = 1350mAh 3s1 p 25C Li-Po (Can take up to 2170mAh)Radio = 3CH (or 4CH with optional rudder)Aileron throw = +/- 20 degreesElevon throw = +/- 25 degreesExpo = 45%NOTES:-Bevel or curve all leading edges・Trim and sand intake to a curve・Use Hot Glue for all parts except carb on rod.Protect lower edge of in take and lower fins with packing tape ・ Cormect both Ailerons and Elevons to a single pair of servos.Paint use colours that will stand out in the sky, don't leave it white.Missile (attach to wing tip)Missile (attach to wing tip)Battery positionCOG7cm to 8cm from wing break.3mm or 4mm Carb on rod epoxy into V slotControl pointControl point23456789 10Control pointMOTOR MOUNT PARTS3mm PLYWOODGlue Plywood onto DepronDoublersHatch to acces electronics and batteryControl points(Make 4 from old plastic credit card)IIIIn take leadi ng edge (Depron or Balsa)111IU 1\ Doublers used in corners J1T /DoublersUpper FuseCut here for rudder (Optional)Rudder Servo (Optional) I。