1#EPS装饰线条安装节点

封面作者：PanHongliang仅供个人学习EPS装饰线条安装节点一、线条安装需在外墙抹灰、门窗安装及保温完成验收后施工，先安装固定垂直平面饰线-安装60*60*5镀锌钢板（用© 8膨胀螺丝固定，入墙 50mm ）焊接40*40镀锌方钢 k安装构件（用聚合物粘结砂浆满粘于墙面）安装镀锌丝杆用发泡胶或fEPS装饰构件填板缝抹平封闭：如下图所示；1.2.3.二、波浪板线条类安装线条安装需在外墙抹灰、门窗安装及保温完成验收后施工，先安装固定垂直平面饰线安装构件（用©8膨胀螺丝固定,入墙50mm，再用聚合物粘结砂浆满粘于墙面）；如下图所示线条安装需在外墙抹灰及保温完成验收后施工，安装固定垂直 平面饰线安装热镀锌支架安装构件（用聚合物粘结砂浆满粘于 墙面）安装镀锌丝杆用发泡胶或 EPS装饰构件填板缝抹平封 闭；如图构件构件拼装缝处理节点2粘接缝宽不大于 3mm时，在安装完的次日进行拼缝的砂纸打磨处理，使用线条用专用抗裂砂浆粘贴100mm宽玻纤网格布，厚度小于2mm ；粘接缝宽大于3mm时，缝内用薄聚苯 片填塞后，再使用 CBMA25罩面砂浆粘贴100mm宽玻纤网格 布加强。干燥后，若线脚拼缝处留有多余砂浆处理方法同上。版权申明本文部分内容，包括文字、图片、以及设计等在网上搜集整理。版权为潘宏亮个人所有This article in eludes some parts, in cludi ng text,pictures, and desig n. Copyright is Pan Hon glia ng's pers onal own ership.用户可将本文的内容或服务用于个人学习、研究或欣赏，以及其他非商业性或非盈利性用途，但同时应遵守著作权法及其他相关 法律的规定，不得侵犯本网站及相关权利人的合法权利。除此以 外，将本文任何内容或服务用于其他用途时，须征得本人及相关权 利人的书面许可，并支付报酬。Users may use the contents or services of thisarticle for pers onal study, research or appreciati on, andother non-commercial or non-profit purposes, but at thesame time, they shall abide by the provisions of copyrightlaw and other releva nt laws, and shall not infringe upon the legitimate rights of this website and its releva ntobligees. In addition, when any content or service of thisarticle is used for other purposes, written permission and remun erati on shall be obta ined from the pers on concerned and the releva nt obligee.转载或引用本文内容必须是以新闻性或资料性公共免费信息为 使用目的的合理、善意引用，不得对本文内容原意进行曲解、修 改，并自负版权等法律责任。Reproducti on or quotatio n of the content of thisarticle must be reas on able and good-faith citati on for the use of n ews or in formative public free in formati on .It shall not misi nterpret or modify the orig inal inten ti on of the content of this article, and shall bear legal liability such as copyright.